Handyflow Oversink Vented Point of Use 5 litres HF05LM
Available
Couldn't load pickup availability
Ideal for portable buildings, offices, shops, workshops, garages and other small commercial premises, the Handyflow combines simple installation with reliable hot water for lower-demand applications.
- Open outlet heater to supply hot water to a single sink
- Installation: Must be sited above a sink using the wall fixing bracket supplied, with the spout and tap located at the bottom of the unit. Cable pre-wired (1m) to save time on installation
- Stylish design and slimline profile - depth only 7” (180mm)
- 2.0kW element
- Neon element on indicator
- External temperature control with frost protection setting
- Comes complete with tap and 10” (250mm) chrome spout
- Thermal cut-out can be reset rather than needing to be replaced
- No need for expansion vessel, relief valve or reducing valve
- Water tank: Polypropylene
- Outer Casing: Easy clean, high impact plastic
- Element type: Copper-sheathed type element
- Thermostat: Capillary type adjustable to approx. 80⁰C. E setting approx. 55⁰C
- Insulation: High density polystyrene CFC free
- Water Pressure: Min 0.3 bar - Max 8.0 bar
- Water Connection: Inlet valve/tap 1 x 15mm compression. Outlet 1 x chrome plated brass spray arm.
- Product Approvals: CE, UKCA
- Warranty: 1 year parts or replacement warranty
- IP24
Description
Description
The Handyflow Oversink is a compact 5 litre vented water heater designed to provide convenient point-of-use hot water for light, occasional dishwashing at a single kitchen sink. Supplied complete with a tap and chrome spout, its slimline design makes it a practical solution where a local hot water supply is required.
Ideal for portable buildings, offices, shops, workshops, garages and other small commercial premises, the Handyflow combines simple installation with reliable hot water for lower-demand applications.
Dimensions & weight
W270mm x D180mm x H400mm - 2.9Kg empty; 7.9Kg full
Heat up time: 6mins (Minimum theoretical heat up time for 70% tank capacity from 10°C to 60°C)
Safety
- Open outlet non-pressurised system, supplied tap and spout must be used
- Safety resettable thermal cut-out
- Frost protection setting when power is switched on
Heating Cycle
It is normal for the spout on this type of unit to drip slightly during the heating cycle, caused by the water expanding as it heats up
ONLY USE THE FITTINGS SUPPLIED SO THAT THE UNIT IS NOT PRESSURISED


