The Franke Aqua130 is a WRAS approved Protronic-S battery operated mixer tap which produces a water saving, low flow rate of 6 lpm, assisted by a theft proof aerator with integrated flow regulator. This attractive piece allows both hot and cold water to be connected direct, leaving the user to adjust the temperature lever on the tap body for their own comfort. Tough and durable with vandal resistant properties, this is made from brass and covered in a polished chromium plated finish.
The mixer lever can be adjusted to set the maximum temperature allowed through the tap. The temperature can also be fixed and the mixing lever completely removed via a conversion set. A great safety feature but also allows for control of energy savings.
Being WRAS approved it demonstrates compliance with the Water Supply (Water Fittings) Regulations or Scottish Byelaws which require that a water fitting should not cause waste, misuse, undue consumption or contamination of the water supply and must be ‘of an appropriate quality and standard.
It’s suitable for a host of locations due to the flexibility of a minimum and maximum water pressure range between 1bar and 10bar, however for peak performance it’s recommended water pressure is 3 bar.
For enhanced sanitary purposes, a hygiene flush can be set on or off to activate after 24h of non-use. A flow will run for 10 seconds after this inactive period to flush out any stagnant water.
The sensor can be programmed to detect either a static or a moving object. This allows for specific differences in washroom locations for things like reflections from washbasins.
The tap will show information such as status of the hygiene flushing and last flush-process in hours. Idea for facilities managers to monitor servicing requirements.
To prevent vandalism and misuse, the tap will only run for 60 seconds of continuous activation.
Franke Aqua130 is a WRAS approved electronic pillar-tab self-closing mixer tap with polished chromium-plated brass finish. It includes an opto-electronic sensor, deck mounted using a taphole type. The spout has a 102.00 mm projection into the washbasin area. Battery operated using supplied 6V lithium CR-P2 with casing located under the washbasin and connected to the bottom of the product. Recommended water pressure is 3 bar (1 – 10 bar range) giving an aerated flow rate of 6lpm. Internal diameter of pipe is DN15 with a connector size of G3-8. Protective shutdown included with a continuous flow time of 60 seconds. Option to hygienically flush the tap which will activate after 24 hours of non-use if switched on.